I e-mailed Bondtech and they advised me to put som electrical tape on the heatsink to prevent that. I could easily twist it with two fingers. I have only printed PLA and PETG with it.Ī heads up if you decide to buy one, make sure the heatsink gets tight enough, mine did not. On the other hand I haven't noticed anything getting worse or bad in any way. Theoretically it's a God sent but honestly I'm a bit disappointed. I've had my Bondtech extruder for a week now with the stock E3D V6 and so far I really can't say if it improved anything. RE: Bondtech Extruder with Mosquito or Stock E3D V6 hotend? Is it even worth it? Second question is are the LDO Slim Power pancake motors worth it?
BONDTECH VS HEMERA UPGRADE
Does it mean if I choose not to buy the mosquito hotend right now, and plan on getting the bondtech with prusa e3d v6 hotend, i wont be able to add a mosquito hotend later on this extruder?Īlso what other parts do i need to upgrade to this extruder? one says with mosquito hot end, other with stock prusa hotend. I see there are different upgrade options for mk3s.
I can spend the extra bucks if bondtech can reduce noise, ghosting, scaling etc to some extent, or even if its future proof with filaments I would like to try in the future. I wont be printing a lot of "other" filament types, but mainly PLA, and sometimes PETG. I'd hate to strip down all the cables and nuts and bolts after setting it up perfectly. I was wondering if i should get the Bondtech extruder before hand the printer arrives, so that i can assemble that with the printer when i am first setting it up. So my MK3S is on pre-order and should arrive in 2 weeks. Even though I was using a Wade’s on my printer, I still had issues now and again that caused failures. Titan should work just fine and I assume that the Bondtech will work due to its mechanics combined with a geared Nema17 motor. I have not found one negative review about it. To properly use 3mm, you need something like a Wade’s geared extruder.
I have been reading a lot about Bondtech extruders on facebook. Bondtech Extruder with Mosquito or Stock E3D V6 hotend? Is it even worth it?
0 kommentar(er)
